Determining Rock Strength

In geomechanical modelling, rock strength refers to the ability of the rock to withstand the in-situ stress environment around the wellbore or perforation cavity. A rock strength model is developed using log based models calibrated with core data where available.  This allows a continuous, foot-by-foot, rock strength prediction model to be developed.

Core Data:

The following rock property data are typically required to populate geomechanical and sanding evaluation models:

  • Unconfined Compressive Strength (UCS)
  • Thick Wall Cylinder Strength (TWC)
  • Cohesive strength
  • Friction angle
  • Static Young’s modulus
  • Static Poisson’s ratio
  • Biot poro-elastic factor

Definitive data are only available from rock mechanics tests on core.  However, core is discontinuous and rock strength data coverage is inherently limited, hence rock strength evaluation is normally based on log indicators calibrated where possible against viable core data. Where core is not available, reliance is placed on uncalibrated log based strength models which increases uncertainty in the analysis.

Log Strength Modelling:

There are a number of published log-core strength correlations that can be used to develop a continuous rock strength model.  These tend to be constrained by log data availability.  Most log models involve correlations between unconfined compressive strength (UCS) and logs which are sensitive to rock strength variations, particularly sonic (DTC and/or DTS), density (RHOB) and porosity (PHIT and PHIE). 

The principal requirement for a log-derived model is that it should provide an accurate description of rock strength in uncored (or unsampled) intervals and wells.

RockMohr Ltd will design a rock test specification document and work with the selected laboratory to ensure fit-for-purpose data for geomechanical modelling.  Strength models can then be built for use in sand failure analysis, wellbore stability or for other geomechanical analysis.